Honeywell Hot Water Heater Control Settings. First, turn the temperature control knob to the “off” position and wait 5 or 10 minutes. 6 rows the reset button on the honeywell water heater is the pilot light knob.
Honeywell WT8840B1000 Water Heater Gas Control Valve NAT 160 Degree F 1 from masa.aero
2 flashs = thermopile low voltage. On newly installed water heaters, it may take 2 to 3 lighting attempts before the pilot lights and status light starts blinking. And impress the o key k to save.
The Honeywell Home Trademark Is Used Under License From Honeywell International.
How to set temperature on an electric water heater. If the thermostat is defective, replace the gas valve and thermostat assembly. 1 flash = normal operation.
2 Flashs = Thermopile Low Voltage.
To determine if the thermostat is defective, assess hot water temperature from the nearest faucet. Install control to water tank 1. Andy h on 8 october 2015 at.
Heat Or Cool Is The Most Recommended Thermostat Settings On Weekdays.
Replace the insulation and panels, then restore power. We recommend a set temperature of 120 degrees. This diff is set to its lowest value:
Adjusting A Honeywell Gas Valve Is Very Simple.
After you’ve adjusted your gas or electric water heater thermostat settings, you may find that you need to tweak them once or twice to find the optimal setting. Check out the honeywell water heater status light codes, descriptions and possible remedies. I then end up on the “low” setting.
The Dial Says Hot, A,, C, And Very Hot.
After that, switch to “hot” for 10 seconds and to “pilot” for 10. 7 flashes = gas control valve failure. Do not recommend whirlpool hot water heaters with honeywell gas control valves!
Location:
Share :
Post a Comment
for "Honeywell Hot Water Heater Control Settings"
Post a Comment for "Honeywell Hot Water Heater Control Settings"